![]() Repeat these steps to clean and then reinsert the other ink cartridge. Wait for the ink cartridge and carriage contacts to dry before you continue (approximately 10 minutes). ![]() Lightly dampen another clean foam-rubber swab or lint-free cloth with distilled water, and then clean the electrical contacts in the carriage, located inside the printer. Lightly dampen a clean foam-rubber swab or lint-free cloth with distilled water, and then clean the contacts. Do not smear any ink or debris elsewhere on the ink cartridge. Gently wipe the contacts with a dry swab or lint-free cloth until they are free of debris.īe careful to wipe only the contacts. Inspect the copper-colored contacts for ink and debris buildup. Do not leave an ink cartridge outside the printer for more than 30 minutes.įigure : Holding the ink cartridge by its sides ![]() Remove and then clean each ink cartridge one at a time. Press down on the ink cartridge to release it, and then pull the ink cartridge toward you to remove it from its slot.ĭo not remove both ink cartridges at the same time. Repeat these steps for the other ink cartridge, if necessary.įigure : Closing the ink cartridge access doorĬlean, dry foam-rubber swabs or a clean, lint-free clothĭistilled or bottled water (tap water might damage the ink cartridge or the printer)ĭisconnect any cords connected to the printer, such as the power cord and USB cable. Install the color ink cartridge on the left and the black ink cartridge on the right.įigure : Snapping the ink cartridge into place Hold the ink cartridge by its sides with the contacts toward the printer, insert the ink cartridge into its slot, and then gently push the ink cartridge until it snaps into place. Inspect for and remove any protective tape from the contacts.ĭo not try to remove the copper electrical strip. Touching these parts can result in clogs, ink failure, and bad electrical connections.įigure : Do not touch the contacts or nozzles Gently press down on the ink cartridge to release it, and then pull the ink cartridge out of its slot.ĭo not touch the copper-colored contacts or the ink nozzles. Wait until the printer is idle and silent before you continue. The carriage moves to the center of the printer.įigure : Opening the ink cartridge access door Make sure the ink cartridges are correctly installed I understand that the new cartridge is showing empty.Ĭlean the electrical contacts of the ink cartridge?Ĭlean from the software/automated tool if it has a front panel?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |